HydroDome Stormwater Chambers Certified for Load Bearing

| From
HydroDome stormwater chambers

ROCKLEDGE, Fla., Aug. 31, 2011 (SEND2PRESS NEWSWIRE) -- LRM Industries International, Inc., headquartered in Rockledge, Florida, announces ASSHTO H-25 load certification for its two unique, high-efficiency HydroDome(TM) stormwater chambers.

Concurrently, LRM introduces the new HydroDome(TM) 300, a low profile complement to the original HydroDome(TM) 610 with the same unique cellular, nesting design. At less than 23 inches tall, this new chamber is ideal for shallow applications in high ground water areas, while still providing a high chamber capacity of 37.8 cubic feet.

Both the HydroDome(TM) 610 and the new HydroDome(TM) 300 exceeded ASSHTO H-25 load-bearing requirements in testing certified by independent engineering firms. LRM's HydroDome(TM) chambers are uniquely manufactured using its proprietary patented STF Sheetless ThermoForming(TM) technology, and are a reinforced composite material structure, providing unmatched strength and stiffness.

As with all of LRM's products, no VOCs are emitted during manufacturing and all trim is recycled back into the process on-site. LRM uses only thermoplastic resins for closed-loop recycling.

Company Information:

LRM Industries International, Inc. was established to commercialize TPF ThermoPlastic Flowforming(TM) technology, a radically different and award-winning process technology for producing large, feature-rich, long-fiber reinforced thermoplastic composite parts in one fully automated operation. With the TPF ThermoPlastic Flowforming(TM) and the new STF Sheetless ThermoForming(TM) technologies, LRM enables innovative applications and designs in the use of thermoplastics/composites to produce very large unitary structures where, to-date, it has been viewed as cost prohibitive or lacking in strength and structural integrity. Visit .

Jim Callough
of LRM Industries International, Inc.

- RSS News feed for LRM: .

News Source:
Like, Share, Save this press release:
  TWEET   SHARE   G+   PIN IT   STUMBLE   LinkedIn   Instapaper   Buffer

The content of the above press release was provided by the “news source” (LRM Industries International, Inc.) or authorized agency, who is solely responsible for its accuracy. Send2Press® is the originating wire service for this story and content is Copr. © 2011 LRM Industries International, Inc. with newswire version Copr. © 2011 Send2Press (a service of Neotrope). All trademarks acknowledged.

Rights granted for reproduction by any legitimate news organization. However, if news is cloned/scraped verbatim, then original attribution must be maintained with link back to this page as “original syndication source.” Resale of this content for commercial purposes is prohibited without a license. Reproduction on any site selling a competitive service is also prohibited. Information is believed accurate, as provided by news source or authorized agency, however is not guaranteed, and you assume all risk for use of any information found herein/hereupon. This work is licensed under a Creative Commons Attribution-NonCommercial 3.0 Unported License.
STORY READS for this single page only, as of Oct 24 2016:
[ count retired 8.4.16 ]

back to top
REFERENCES: HydroDome stormwater chambers, Plastics and Chemicals, TPF ThermoPlastic Flowforming, HydroDome 610, HydroDome 300, ASSHTO H-25 load-bearing requirements, storm water chambers, reinforced thermoplastic composite, Florida business news, news, press release from LRM Industries International, Inc., Aug 31, 2011, Manufacturing, Construction, Product Launches, Rockledge, Florida, HydroDome Stormwater Chambers Certified for Load Bearing